View Current
Time of Use Rate
9.8 ¢/KWh Off-Peak
innpower Logo

Outages and Safety


				

Planned Outage - 9th Line Metrolinx Crossing

Feb 27, 2024
9:00 am - 1:00 pm

A planned outage will be taking place Tuesday, February 27th at the 9th Line Metrolinx Crossing while crews replace non-approved terminations. The outage will begin at 9:00 am and is estimated to last 4 hours. All impacted customers have been notified.

Should the outage have to be postponed, the outage will take place Wednesday, February 28th at the same time.

We regret any inconvenience this may cause. Thank you for your patience and cooperation.


x

Paymentus & MyAccount Service Delays

Customers may currently experience delays when accessing the MyAccount portal or making payments through the Paymentus online and phone payment system. 

Customers can still make payments in-office, through their financial institution or pre-authorized payment options during this time. We appreciate your patience while the issue is being resolved.
View Alternative Payment Options
x

DISCLAIMER:

This hosting capacity map is provided for informational purposes only. It is not intended to be, and should not be relied upon as, a basis for determining the permissible capacity of distributed energy resources (DERs) that may be interconnected to the distribution system. Separate and specific analysis is required to determine DER capacity on the distribution system. Further, the information, data and materials are provided on an “as is” basis and while InnPower Corporation provides this information in good faith, INNPOWER CORPORATION does not warrant, covenant or guarantee, in an expressed or implied form, arising by law or otherwise, the completeness, effectiveness, accuracy and/or fitness or the information for any particular use. INNPOWER CORPORATION does not assume responsibility nor accept any liability arising from any use of the information. This information is proprietary and may not be reproduced without consent from INNPOWER CORPORATION.

By clicking the "ok" button below I am stating that I understand and accept the above disclaimer.

Ok